Notes On Use - Sony XLR-K3M Help Manual

Adaptor kit

Hide thumbs Also See for XLR-K3M:

Help Guide

XLR Adaptor Kit

XLR-K3M

Notes on use

Before connecting/disconnecting an external microphone or device to/from the INPUT1 or INPUT2 jack, be sure to

set the INPUT1 (LINE/MIC/MIC+48V) or INPUT2 (LINE/MIC/MIC+48V) switch to the position other than "MIC+48V."

While the switch is set to "MIC+48V," plugging/unplugging the cable from the external microphone or device may

cause a loud noise or a malfunction of the device.

To protect the connector of the Multi Interface foot from damage while carrying around this unit, remove the unit from

the camera, attach the connector protect cap to the foot and put the unit in the supplied case.

While this unit is attached to a camera along with other accessories via a mounting bracket (not supplied), such as

Sony VCT-55LH, do not hold the camera with hands for camera shooting. To avoid the risk of an incident caused by

dropping, attach the camera to a tripod.

While recording is in progress, operation and handling noises of a camera or a lens may be recorded. Touching this

unit while recording is in progress causes a noise to be including in the recording.

While recording is in progress, do not change the INPUT1, INPUT2, and DIGITAL/ANALOG switch settings.

If the microphone of this unit is in proximity to a speaker, a howling effect (acoustic feedback) may occur. In such a

case, move the unit away from the speaker to allow the maximum distance between the microphone and the

speakers; or lower the speaker volume.

Use of this unit in the vicinity of a radio tower may cause static noise in recordings. Before camera shooting, make

sure that there is no radio tower nearby.

Before changing the lens, be sure to remove this unit from the camera.

Before changing the lens, make sure that no wind screen fibers are present on the surface of the lens and the

camera body. If present, clean them off with a blower etc. and then change the lens.

If dust or water droplets are present on the surface of the microphone, a successful recording may not be possible.

Be sure to clean the microphone surface before using this unit.

When you are finished with using this unit, lens cleaning is recommended.

While a micro USB cable connected to XLR-K3M, using XLR-K3M may affect its performance.

Using the supplied Extension Cable for Audio with products other than XLR-K3M may affect its performance, leading

to accidents or malfunction.

Table of Contents