Symbol ES3000 User Manual page 264

5-96 ES3000 User Guide
dot1x timeout re-authperiod
Use this command to set the number of seconds between re-authentication attempts. The command
affects the behavior of the switch only if periodic re-authentication is enabled.
dot1x timeout re-authperiod <minute>
S D
YNTAX ESCRIPTION
D V
EFAULT ALUE
C M
OMMAND ODES
R :
EFERENCE
M :
ENU
E :
XAMPLE
! Set re-authentication time 2 min on port 7
Switch(config)# interface fastethernet0/7
Switch(config-if)# dot1x timeout re-authperiod 30
Switch(config-if)#
dot1x timeout supp-timeout
Use this command to set the number of seconds for the timeout value.
dot1x timeout supp-timeout <second>
S D
YNTAX ESCRIPTION
D V
EFAULT ALUE
C M
OMMAND ODES
R :
EFERENCE
M :
ENU
E :
XAMPLE
! Set supp-timeout 60 sec on port 7
Switch(config)# interface fastethernet0/7
Switch(config-if)# dot1x timeout supp-timeout 60
Switch(config-if)#
: <minute>
:
: Interface configuration
Cisco
: <second>
:
: Interface configuration
Cisco
Set the number of minutes
Set the number of seconds