ECS L7SOM User Manual page 46

Power Button Override (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can
be resumed by Wake Up Alarms. This item lets you install a software power
down that is controlled by the normal power button on your system. If the item
is set to Instant-Off, then the power button causes a software power down. If
the item is set to Delay 4 Sec. then you have to hold the power button down
for four seconds to cause a software power down.
PM Wake Up Events
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
IRQ [3-7, 9-15], NMI
IRQ 8 Break suspend
Ring Power Up Control
PCIPME Power Up Control
Hot Key Power Up Control
USB Resume from S3
KB Power ON Password
Power Up by Alarm
x Month Alarm
x Date (of Month)
x Time (hh:mm:ss)
- ¯ ® ¬
: Move Enter : Select
F5:Previous Values
This item opens a submenu that enables you to set events that will resum e
the system from a power saving mode.
IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the
system to wake from a power saving mode.
IRQ 8 Break Suspend
Determines whether the system will monitor IRQ 8 activity and wake the sys-
tem from a power saving mode when IRQ 8 is activated.
Ring Power Up Control (Disabled)
Use this item to enable LAN or modem activity to wakeup the system from a
power saving mode.
PCIPME Power Up Control (Enabled)
Use this item to enable PCI activity to wakeup the system from a power sav-
ing mode.
Hot Key Power Up Control (Enabled)
Use this item to enable a hot key "[CTRL]+[ALT]+[BACKSPACE]" to wakeup
the system from a power saving mode.
PM Wake Up Events
[Enabled ]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Enter]
[Disabled]
NA
0
0 0 0
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
42
Item Help
Menu Level
F1:General Help