Intended Use; Misuse; Declaration Of Conformity; Type Plate - Bosch Worcester Greenstar HIU E Installation And Maintenance Instructions Manual

2.2

Intended use

The appliance provides domestic hot water and central heating to
properties that are serviced from district heating or central boiler plants.
The appliance consists of two heat exchangers, one for the domestic hot
water providing instant hot water at a safe regulated temperature and
the second for central heating. The appliance is indirect so the primary
heating circuit is hydraulically separated from the property central
heating by the second plate heat exchanger. Domestic hot water takes
priority over the central heating demand.
This appliance must only be used as a source of heating and hot water in
a sealed system.
Refer to the details on the type plate and the specifications to ensure
correct use of this appliance.
2.3

Misuse

Appliance must be used as per the intended use statement. Operation
outside the parameters of the intended use is considered misuse and
could cause harm to people and damage to property.
Using the appliance outside of its intended use may also invalidate the
manufacturer's guarantee.
2.4

Declaration of conformity

This product, in design and operation, conforms to the European
Directives and supplementary national requirements.
Compliance is demonstrated by the CE marking.
You can request the declaration of conformity for the product. To do so,
send your request to the address on the back of the manual.
The appliance is tested to the relevant clauses of the following
standards: EN60335,EN62233,EN55014 and EN61000.
6 720 808 928 (2017/06)
2.5

Type plate

Refer to figure 1
The type plate contains information on device performance, the
registration data and the serial number. This is located inside the
appliance cover [2].
There is an addition data label [1] which also has the registration data
and the serial number. This is located on the back plate behind the
control unit.
1
Fig. 1 Type plate location
Customer identification of the appliance
Refer to figure 2
The customer can easily identify the appliance as there is also a
additional data label [1.] This contains information of the appliance
model and serial number and is located on the bottom centre of the
cover panel.
Fig. 2 Customer data label
Appliance information
2
0086
1
7