Keep Warm Function - Salton GK1758 Instruction Booklet

will show the decreasing water temperature as it cools.
9. To use the variable temperature settings:
- Press the "-" or "+" buttons until you reach the desired temperature
between 40 –100°C (104 – 212°F) in 10 degree Celsius increments.
- To switch between the Celsius and Fahrenheit display, press the
°F/°C button once.
- The display will show the chosen temperature for 3 seconds then
will shut switch to the actual water temperature. The display
temperature will increase until it reaches the chosen temperature.
- Once the temperature has reached the set temperature the Kettle
will shut off and beep three times, the display will show the deceasing
water temperature as it cools.
10.IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) If the kettle is removed from the base before the boiling cycle is
complete the boiling cycle will be cancelled.
c) To turn the kettle off before the boiling cycle is complete press the
Power Button.
11.The Lid should not be opened when the Kettle is hot.
12.Only grip the Kettle by the Handle as all other surfaces will be hot.
13.Return the Kettle to the Base or a heat resistant surface after use.
14.IMPORTANT: If the Kettle is accidently switched on when empty, the
thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs unplug the Kettle
immediately and allow the Kettle to cool before refilling.
15.It is recommended that the Power Cord be disconnected from the wall
outlet when not in use.
16.DO NOT attempt to connect any other appliance to the Power Base
or tamper with the connector in any way.

KEEP WARM FUNCTION

1. Hold the Power Button for 3 seconds, then press the '-' or '+'
buttons until you reach one of the 7 desired 'keep warm'
temperature settings between 40 - 95°C (104 – 203°F).
IMPORTANT: The Keep Warm Function cannot be used for the
100°C/212°F temperature setting.
2. The °C/°F on the display will flash when the Keep Warm function has
been activated.
NOTE: The Keep Warm function will keep water at the preset
temperature for 2 hours. The kettle can be removed from the Base
for 2-3 minutes otherwise the Keep Warm function is cancelled
and the display will show the current water temperature in the kettle.
5