Table of Contents
Advertisement
10. View the TV programs
After tunning and saving the TV channels, you can watch the TV channels by
following:
Press the
button on the TV to select the channel you want to watch.
Also can enter the channel number to select the channel directly. In this case you
will use the ten-keys on your remote control to enter the number. For example, just
press
to select channel 8.
If want to enter a double-digit channel number, first press the Channel Entry
button 100/- 确认 ( 确认 -/--), then press the corresponding ten-keys buttons, For
example, to select channel 28, press 100/- 确认 ( 确认 -/--), and then
The remote controll also provide you a shortcut to return to the previous channel.
Just press the return
previous one.
Press the 音量 + or 音量 - button on the controller, or the + VOL or VOL - button
on the TV to adjust the volume. In this case, a volume indicator will be shown on
the screen.
For more informaion about this TV and its setup, please refer to the second part of this
manual, "User Manual".
This LCD TV has been designed to provide high resolution display.To obtain the best display
quality, connecting to a digital signal source is recommended. In this case, you shall set the
output resoultion of the source to match your TV resolution, and select a proper aspect ratio,
such as "4:3" or "Panorama" when you are watching traditional (analog) programs. For more
detaild information regarding the aspect ratio and how to set it, please refer to the second
part of this manual.
Care and cleaning information
Always turn off the display and disconnect it from the mains power before cleaning.
Do NOT use cream, liquid, aerosol or spray cleaners. Use only a slightly damp well
wrung-out (drip-free) and lint-free, clean soft cloth and lightly wipe the display.
If necessary, use a pH-neutral liquid dish-washing detergent diluted with water on a
separate clean lint-free cloth to remove oil or grease marks. Wipe over again with a
cleandry lint-free cloth to remove any smear marks.
Under close examination and in certain circumstances, you may notice that a few
non-active pixels appear on the screen as a fixed point of colour. Please note that
this does not affect the performance of your product as it is usually not visible at
normal viewing distances.
If the display is not going to be used for an extended period of time (like when you
are going away for holidays), it should be switched off and unplugged from the wall
outlet. You should also consider removing the batteries from the remote control (as
they may leak)
LCD (Liquid Crystal Display) screens, like plasma (PDP) and conventional CRT
(Cathode Ray Tube) screens, are also susceptible to 'screen burn-in' or 'image
retention' which can be found on the screen as visible fixed lines and shades and
can't be removed. To avoid such permanent damage to the screen, please take the
following preventive measures when using your TV:
10
Part I: Quick Start Guide
button on the remote control, or the ▲ CH or CH ▼
or
( 返回 ) button, and the channel will be switched to the
,
.
Advertisement
Table of Contents
