Table of Contents
Advertisement
ND611 (B-2) : COM1 CPU status LED
PERIPH LAN control IC status indication.
ND900 (B-4) : MAIN CPU status LED
Main CPU status indication.
ND901 (B-4) : MAIN CPU status LED
Main CPU status indication.
<Switch>
S310 (A-4) : MAIN RESET switch
Reset switch for the entire CA-45 board.
S311 (A-4) : Monitor reset switch for the main CPU
Reset switch that is used during maintenance of the main
CPU from the TERMINAL pin.
S480 (A-3) : C0-RESET switch
Independent reset switch for the CTRL LAN control IC.
S481 (A-3) : Modes setting switch for COM0 CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
S482 (A-3) : Monitor reset switch for the COM0 CPU
Reset switch that is used during maintenance of the CTRL
LAN control IC from the TERMINAL pin.
S610 (A-2) : C1-RESET switch
Independent reset switch for the PERIPH LAN control IC
CPU.
S611 (A-2) : Modes setting switch for COM1 CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
S612 (A-2) : Monitor reset switch for the COM1
CPU
Reset switch that is used during maintenance of the
PERIPH LAN control IC from the TERMINAL pin.
S900 (A-4) : Mode setting switch for the main CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
S901 (A-5) : Unit ID setting switch for LAN
Sets the unit ID of the equipment inside the network.
Used to set the unit ID for the CTRL, PERIPH and DATA
terminals.
Refer to the System Setup Manual for details.
CCP-9000
1-9. Setting of On-board Switches and Function of LEDs
S902 (A-5) : Group ID setting switch for LAN
Sets the ID of the network group.
Used to set the group ID for the CTRL, PERIPH and
DATA terminals.
Refer to the System Setup Manual for details.
S903 (B-5) : STATION ID
Used to set the REMOTE terminal.
Refer to the System Setup Manual for details.
<Connector>
CN203 (H-9) : TERMINAL pin
Main CPU connection terminal.
Used only for production in the assembly factory.
CN482 (H-9) : TERMINAL pin
CTRL LAN control CPU connection terminal.
Used only for production in the assembly factory.
CN612 (J-9) : TERMINAL pin
PERIPH LAN control IC CPU connection terminal.
Used only for production in the assembly factory.
CN803 (B-9) : JTAG connector
Used only for production in the assembly factory.
<LED on the CPU DR module> : Main CPU
D10 (green) (A-1) : RUN status LED
RUN status indication.
Lit when the CPU-DR module starts operating.
D12 (green) (A-4) : CD (Card Detect) status LED
Lit when the CPU-DR module is inserted correctly to the
parent board.
D13 (green) (A-1) : +2.5 V
Indicates the statue of the +2.5 V power that is generated
by the VCC (CORE) and supplied to the CPU-DR module.
Lit while the specified power is turned on.
D14, D15, D16, D17 (A-3) (green) : STATUS1 to
STATUS4 status LEDs
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
D18 (green) (A-4) : +3.3 V
Indicates the status of the VCC (I/O) power that is supplied
to the CPU-DR module.
Lit while the specified power is turned on.
1-21
Advertisement
Table of Contents
