Set-Up Position; Adjusting The Cutting Depth; Adjusting The Mitre Angle; Changing Tools - Festool PRECISIO CS 70 EB Original Operating Manual/Spare Parts List

er supply is interrupted permanently if the
motor is blocked for a few moments. Switch
the machine off and on again to reset.
Temperature cut-out
The machine power supply is limited and
the speed reduced if the motor exceeds a
certain temperature. The machine contin-
ues operating at reduced power to allow
the ventilator to cool the motor quickly. The
machine starts up again automatically once
the motor has cooled suffi ciently.
Brake (CS 70 EB only)
After the machine switches off, the saw
blade is electronically brought to a stand-
still in 3 seconds.
Restart protection
The integral undervoltage release prevents
the machine from automatically starting up
again after an interruption in power when
the machine is used in continuous operat-
ing mode.
The machine will have to be switched back
on in this case.

7.2 Set-up position

Always move the saw to set-up position be-
fore making any adjustments:
The saw is locked in rest position on deliv-
ery.
Turn the rotary knob [2-6] anticlockwise
to release the lock and pull the saw for-
wards.
Push the stop lever [1-7].
The saw is locked in the front position.

7.3 Adjusting the cutting depth

Proceed as follows to adjust the cutting
depth in set-up position to any setting be-
tween 0 - 70 mm:
Turn the cutting depth adjuster [1-8].
Set a cutting depth 2 - 5 mm greater
than the thickness of the workpiece to
produce a clean cut.

7.4 Adjusting the mitre angle

The saw blade can be tilted between 0° and
45° in set-up position:
Unscrew the rotary knob [2-4].
Adjust the mitre angle using the rotary
handle [2-3] with reference to the scale
[2-5].
Tighten the rotary knob [2-4].
The saw blade can be tilted 2° beyond the
two end positions for precision trimming
work (undercuts on abutting edges).
Press and hold the button [2-2] in the
end position.
The saw blade can now be tilted from -2° to
47° using the rotary handle [2-3]. Release
the button [2-2] to reactivate the 0° and
45° stops.

7.5 Changing tools

Removing saw blades
Lock the saw in set-up position.
Set the widest inclination angle and the
maximum cutting depth.
Loosen the clamp on the insert via the
rotary knob [5-1].
Slide the clamping plate forwards.
Reach underneath the table insert [1-4]
from the back and remove by lifting away
from the back of the table.
Remove the protective cover.
Swivel the cover [5-10] backwards.
Remove the hexagon wrench [5-3] from
the store on the base [5-6] and insert in
the saw blade retaining screw.
Press and hold the spindle stop [5-2] (be-
hind the saw blade) and use the hexagon
wrench to turn the saw shaft until the
spindle stop [5-2] engages and the saw
shaft locks.
The saw blade retaining screw has a
left-handed thread.
Firmly turn the saw blade retaining screw
clockwise and remove the clamping fl ange
and the saw blade.
Installing saw blades
WARNING
Risk of injury
Observe the rotation direction when at-
taching a new saw blade: the rotation
direction on the saw blade [5-4] must
correspond with the rotation direction
on the machine.
PRECISIO -
GB
17