Operation; Installation Checklist Before Operation; First Time Operation - EdgeStar PIM300SS Owner's Manual

Operation

Installation Checklist before Operation

1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?
2. Have the installation instructions been followed, including connecting the machine to electricity?
And has proper grounding been installed for the ice maker?
3. Is the ice maker in a site where the ambient temperature is between 50° F and 90° F all year
round?
4. Has the unit been thoroughly cleaned prior to use?
5. Is there a clearance of at least 4" around the back and sides of the unit?

First Time Operation

1. Pour water into the water reservoir. Keep the water level below the "MAX" water mark.
2. Insert the ice basket into the water reservoir.
3. Close the lid.
4. Plug the ice maker's power plug in to a grounded outlet.
5. Press the On/Off button on the Control Panel.
6. Press the Select button to choose between small, medium, and large size cubes. If the room
temperature is lower than 60°F, it is best to select the small size setting; otherwise, the ice cubes may
stick together.
7. The ice making cycle should produce one batch of ice in approximately 13 muntues.
Note: Discard the first 2 batches of ice produced by the ice maker.
!
Note: If the water pump is unable to detect or pump water, the unit will stop automatically,
and the "Add Water" indicator will illuminate. Once you have added water to the unit, it will
!
restart automatically and continue making ice as normal. Do not power on the unit without
any water.
9