Siemens SIMATIC Field PG P4 Manual page 80

Configuring the SIMATIC Field PG P4
"Hardware Options" Field
The following submenu appears when you select the "Hardware Options" field in
the main menu:
Fig. 5-8
The parameters of the interfaces present on the basic module are set here.
Entry
PCI - MPI / DP
Programming interface Displays enable or disable status of the SIMATIC Memory Card
Cardbus / PCMCIA
Slot
5-12
PhoenixBIOS Setup Utility
Main
Hardware Options
[ Enabled
PCI – MPI / DP:
Programming interface: [Enabled]
[Enabled]
Cardbus / PCMCIA Slot:
[Enabled]
Onboard Ethernet
08000624E1CB
Ethernet Address
[Disabled]
LAN Remote Boot:
CRT / LCD selection: [Simultan Auto]
LCD-Screensize:
[Expanded]
Frame Buffer Size: [32MB]
[Auto Detect]
Touchpad
[Enabled]
Onboard Audio Device
Help Select Item
F1
ESC Exit Select Menu
"Hardware Options" Submenu
Enables the CP5611 compatible MPI/DP interface.
Interface. Enable follows the enable of PCI-MPI/DP.
[Disabled]
[Enabled]
Item Specific Help
Enable or disable the
]
PCI - Multi Point
Interface (MPI/DP).
Also, this item
Enables / Disables the
SIMATIC programming
interface.
+ / – Change Values F9
Select
Enter Sub-Menu F10
Meaning
Enable Cardbus / PCMCIA-
interface deactivated.
Resources are managed by BIOS PCI
Plug & Play mechanisms.
SIMATIC Field PG P4 Manual
Setup Defaults
Save and Exit
A5E00180080-04