Jenn-Air JIM1550ARB Service Manual page 29

Cabinet Cut-Out Dimensions
and Specifications
Cut-out Height: 34 1 " minimum
⁄
2
Cut-out Width: 15"
Cut-out Depth: 24" minimum
Locate outlet
on back wall
to local codes.
34 1 " Min.
⁄
2
to
35 1 " Max.
⁄
4
Floor Drain
15"
Water supply should enter
cutout from right rear wall.
24"
Min.
24 3 "
⁄
4
34 1 " Min.
⁄
4
Adjustable
to 35"
14 3 "
⁄
4
Leveling Legs
Install leveling legs (located in the literature pack):
• With at least 2 people, tip ice maker backwards
until there is approximately 12" of clearance
between the floor and the ice maker.
• Screw one front leveling leg into the screw
impression found in each corner. Leveling legs
should be screwed in until snug.
Impressions
Bottom
of Unit
• Secure the door and repeat the above
procedures to install the rear leveling legs.
WARNING
•
One person should not attempt to tilt the ice maker
by themself. Have someone else assist to prevent
the ice maker from falling during leveling leg
installation.
CAUTION
•
The ice maker should remain upright at least
30 minutes prior to plugging it in.
Level the Ice Maker
Using a carpenter's level, check to be sure the ice
maker is level from side to side and from front to back.
Leveling adjustments can be made by turning the
leveling legs counter-clockwise to increase height and
clockwise to reduce height.
NOTE: The ice maker should not wobble. Use shims
to add stability when needed.
Screw
5