Panasonic KX-TU150 Operating Instructions Manual page 8

Note for the battery symbol
This symbol ( ) might be used in combination with a chemical symbol. In this case it complies
2
with the requirement set by the Directive for the chemical involved.
Note for the battery removal procedure
Remove the phone's cover ( ), and lift the
battery ( ), then remove it ( ).
2
Trademarks
● Micro SDHC Logo is a trademark of SD-3C, LLC.
● The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc.,and any use of such marks by Panasonic Corporation is under licence.
● All other trademarks identified herein are the property of their respective owners.
Notice
● The phone supports microSD and microSDHC memory cards. In this document, the term
"microSD card" is used as a generic term for any of the supported cards.
Ecodesign information
Ecodesign information under EU Regulation (EC) No. 1275/2008 amended by (EU) Regulation
No. 801/2013. From 1 January 2015.
Please visit here: http://www.ptc.panasonic.eu/erp
Click [Downloads]
→
Energy related products information (Public)
Power consumption in networked standby and guidance are mentioned in the web site above
SAR
This model meets international guidelines and EU requirements for exposure to radio waves.
Your wireless device is a radio transmitter and receiver. It is designed not to exceed radio wave
exposure limits recommended by international guidelines. These guidelines were developed by
the independent scientific organisation ICNIRP and include safety margins designed to assure
the protection of all persons, regardless of age and health. These guidelines also form the
basis of international regulations and standards on RF Exposure.
The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The
SAR limit for wireless devices is 2 W/kg.
The highest SAR value for this device tested at the head was: 0.427 W/kg
The highest SAR value for this device tested on the body was: 0.969 W/kg
As SAR is measured utilizing the devices highest transmitting power the actual SAR of this unit
while operating is typically below that indicated above. This is due to automatic changes to the
1
3
8
2
3
1
*1