IBM Hardware Management Console Installing And Configuring page 60

Figure 31. Using the release latch
Note:
The video cable is connected to the flat-panel monitor. When you install the tray in the rack cabinet,
ensure that you do not pinch or cut the video cable.
11. Push the tray into the rack and tighten the four rear slide-rail bracket screws.
12. Place the keyboard on a stable flat surface and remove the two adhesive rubber pads located at each
end of the bottom of the new keyboard. Do not leave the rubber pads on the keyboard, because the
rubber pads might extend into the space below the tray.
Note:
Do not extend the keyboard feet. The flat-panel monitor screen might be damaged if the feet is
extended when the monitor is closed.
13. Pull the tray out of the rack until it is extended fully on the rails.
14. Lift the front of the flat-panel monitor, then raise the monitor to the full upright position.
Figure 32. Raising the monitor to the full upright position
15. Insert the keyboard into the tray. Then, route the keyboard-and-mouse cable through the cord clip on
the bottom of the tray, up through the opening on the right side of the tray, and toward the
cable-management arm. Pull out the full length of the cable through the opening.
16. Place the keyboard and mouse cables on the tray behind the monitor. Ensure that the cables do not
obstruct devices in the rack when the tray is pushed into its position. In the following steps, you will
route the cables through the cable-management arm.
17. Lower the monitor to the down position and then push the tray all the way into the rack. Use the
thumbscrews to secure the front of the tray into the rack.
18. From the rear of the rack, remove the shipping straps that holds the cable-management arm into the
tray.
19. Route the keyboard and mouse cables through the cable-management arm. Use the existing cable
straps to secure the cables.
46
Power Systems: Installing and configuring the Hardware Management Console