Honda GX160UT2 Manual page 51

62Z4H000.book 6 ページ ２０１１年５月２０日 金曜日 午前１０時５分
dummyhead dummyhead
MAINTENANCE
CHAIN TYPE (with clutch)
Place the engine on a level surface and place a suitable
container under the drain plug bolt [1].
Remove the oil filler cap/oil level gauge [2], drain plug
bolt and drain plug washer [3] and drain the oil into a
suitable container.
Please dispose of used oil in a manner that is
compatible with the environment. We suggest you take
used oil in a sealed container to your local recycling
center or service station for reclamation. Do not throw it
in the trash, pour it on the ground, or pour it down a
drain.
Used engine oil contains substances that have
been identified as carcinogenic. If repeatedly left in
contact with the skin for prolonged periods, it may
cause skin cancer. Wash your hands thoroughly
with soap and water as soon as possible after
contact with used engine oil.
Install the drain plug bolt with a new drain plug washer
and tighten it to the specified torque.
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
Add the specified amount of recommended oil into the
SAE 10W - 30 is
reduction case.
recommended for
general use. Other
OIL CAPACITY: 0.50 Liter (0.53 US qt, 0.44 Imp qt)
viscosities shown in
the chart may be
RECOMMENDED OIL:
used when the
SAE 10W-30
average
API service classification: SJ or higher
temperature in your
area is within the
After adding the oil, check the oil level.
recommended
Check that the O-ring [4] is in good condition, replace it
range.
if necessary.
Install and tighten the oil filler cap/oil level gauge
securely.
Make sure there are no oil leaks.
3-6
[2]
[4]
SAE VISCOSITY GRADES
AMBIENT TEMPERATURE
[1]
[3]