Chamberlain RJO70 Manual page 32

Programming
Your hand-held remote control (model 950ESTD) has already been programmed to the door control (Motion-Detecting
Control Panel) at the factory. Below are instructions for programming additional remote controls, keypads, and myQ
enabled accessories to the door control.
REMOTE CONTROL
1. Press the control panel LEARN button twice, and
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
LIGHT ACCESSORIES
1. Press the control panel
LEARN button twice, the red
learn LED will turn on.
2. Press the LEARN button on
®
the myQ device.*
®
* myQ accessories may be
programmed to the 828LM
Internet Gateway.
LEARN
Button
Model PILCEV - Remote Light Control
Light module can be synchronized with
the garage door opener light bulbs.
32
MODEL 940ESTD KEYPAD
1. Press the control panel LEARN button twice, the red
learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keypad. Then press the ENTER
button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
Command
LED (yellow)
Learn LED
(Red)
Model WSLCEV - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
®
? ? ? ?
PIN
LEARN
Button