Chapter 4. Replace Power Supply In Iseries 825 - IBM i Series Manual

Chapter 4. Replace power supply in iSeries 825

To perform this procedure with the system powered on, you must have two power
supplies and two working air moving devices. If you need to replace an air
moving device, go to Chapter 6, "Replace the air moving device," on page 13.
To replace the power supply, perform these tasks:
Note: The figures in these instructions may not look exactly like the server that
__ 1. Perform prerequisite tasks as described in Chapter 2, "Before you begin,"
__ 2. If you need to power down the system, follow the steps in "Power down
__ 3. Remove the back cover. Refer to "825 back cover" on page 20.
__ 4. Locate the power supply to be replaced at the back of the unit (P01 or
© Copyright IBM Corp. 2000, 2005
you have. However, the steps to perform the task are the same.
on page 3.
the system" on page 23.
P02).
7