Alarm Buzzer - Fujitsu CELVIN NAS QE807 Operating Manual

LED Colour
USB Blue

Alarm buzzer

The alarm buzzer can be deactivated under Control Panel - Hardware.
The beep that sounds when the device is started up cannot be deactivated.
Signal tone
Short beep (0.5 sec)
Short beep (0.5 sec)
Short beep (0.5 sec),
Long beep (1.5 sec)
Long beep (1.5 sec)
Fujitsu
LED status
Flashes blue
every 0.5 sec.
Blue
Off
No. of repetitions
1
3
3, every 5 mins.
2
1
Description
• A USB device has been identified at the
front USB port.
• A USB device has been removed from the
front USB port of the NAS.
• Access to the USB device at the front USB
port of the NAS.
• Data is being copied from or to the external
USB device
A USB device has been identified on the front
(after connection of the device).
• No USB device found.
• The NAS has finished copying the data from
or two the USB device at the front USB port.
Description
• The NAS is booting up.
• The NAS is shutting down (software shut
down).
• The user pressed the reboot button to reboot
the NAS.
• The system firmware was updated.
An attempt is being made to copy NAS data
to an external storage device connected to the
front USB port, but the data cannot be copied.
The system fan is not working.
• The hard disk is almost full.
• The hard disk is full.
• All the hard disks in the NAS are in degraded
mode.
• The user starts the hard disk recovery
process.
• The NAS is in forced shut down (hardware
shut down).
• The NAS started successfully and is ready
for use.
Installing the NAS
17