Inflating Tires Or Products With Valve Stems In Manual Mode; Important Auto Mode Operating Notes; Inflating Other Inflatables Without Valve Stems; Important Manual Mode Operating Notes - Stanley AirPro 120 HRC120DS Instruction Manual

desired pressure has been reached, release the Button and wait two seconds. The digital display will flash the new selected pressure,
as in the following example:
This pressure value is now stored in the unit's memory until it is manually reset.
5. Press the Power Button once more to begin inflation. The digital display will only show the current pressure of the object (which will
light solid) to indicate that the compressor is working. Monitor the pressure on the LCD screen.
6. When desired pre-set pressure is reached, the compressor will stop automatically. Press and hold the Power Button for one second to
turn off the unit.
7. Unscrew and remove the SureFit

IMPORTANT AUTO MODE OPERATING NOTES:

• To interrupt the inflation process, press the Power Button once. To resume the inflation process, press the Power Button again.
• To switch to Manual Mode, press the Power Button once to stop the inflation process, then press the Compressor Trigger. (The unit
cannot switch to the Manual Mode while it is inflating.)
• To shut down the unit at any time, press and hold the Power Button for one second.
• To select a new pressure value, press the Power Button once, then press the Increase (+) or Decrease (–) Pressure Control Buttons and
resume the inflation process at step 5.
• After pressing the Power Button at any time during operation, the unit will automatically shut down after one minute if no further
actions are taken.

Inflating Tires or Products with Valve Stems in Manual Mode

In the Manual mode, the Compressor Trigger on the front of the unit is used to operate the compressor until the desired pressure value is
reached.
1. Make sure all charging adapters are disconnected.
2. Screw the SureFit nozzle onto the valve stem. Do not overtighten.
®
3. Press the Power Button to turn the unit on. The backlit LCD Screen will display the following, indicating the unit is in Standby Mode:
The digital display will alternately show the flashing pre-set PSI value (that was last set by the Pressure Control Buttons) for 2 seconds;
then it will flash the current pressure of the item being inflated for 5 seconds (which will then light solid).
IMPORTANT: If no other actions are taken after pressing the Power Button, the unit will automatically shut off after one minute of
inactivity.
4. Press the Compressor Trigger to begin the inflation process. The digital display will only show the current pressure of the object (which
will light solid, as in the following example) to indicate that the compressor is working. Monitor the pressure on the LCD screen.
5. When the desired pressure is reached, release off the Compressor Trigger and the compressor will stop. Press and hold the Power
Button for one second to turn off the unit.
6. Unscrew and remove the SureFit

IMPORTANT MANUAL MODE OPERATING NOTES:

• To interrupt the inflation process, release the Compressor Trigger. To resume the inflation process, press the Compressor Trigger again.
• To switch to Auto Mode, release the Compressor Trigger, then press the Increase (+) or Decrease (–) Pressure Control Buttons or the
Power Button. (The unit cannot switch to the Auto Mode while it is inflating.)
• To shut down the unit at any time, press and hold the Power Button for one second.
• In this mode, the unit will automatically shut down after one minute of inactivity.

Inflating Other Inflatables Without Valve Stems

Inflation of other items requires use of the nozzle adapter.
1. Make sure all charging adapters are disconnected.
2. Screw the nozzle adapter into the SureFit
3. Insert the nozzle adapter into item to be inflated.
nozzle from the valve stem.
®
nozzle from the valve stem.
®
nozzle. Do not overtighten.
®
7