Description; User Controls - Baxi DUO-TEC COMPACT 30 GA Instructions For The End User

1. DESCRIPTION

The boiler is a wall mounted, fan assisted room-sealed combination boiler, providing both central heating and domestic hot water
for the LUNA DUO-TEC 40 and DUO-TEC COMPACT 30 models and only the heating for LUNA DUO-TEC 1.33 model.
After initial lighting of the boiler, it will provide central heating (as required).
Hot water is always available whenever a hot tap is open.

2. USER CONTROLS

To light the boiler correctly, proceed as follows:
• Check that the system pressure is correct;
• Power the boiler;
• Open the gas tap (yellow, positioned under the boiler);
• Select the required heating mode (see section 3.4: "OPERATING MODES").
WARNING
If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage,
personal injury or death.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified installer, service agency or the gas supplier.
BUTTONS Key
DHW temperature adjustment
(+ to increase the temperature and – to decrease it)
Heating water temperature adjustment
(+ to increase the temperature and – to decrease it)
Boiler operating information
Operating mode:
DHW – DHW & Heating – Heating Only
Off – Reset – Exit menu/functions
SYMBOLS Key
Off: heating and DHW disabled
(only boiler frost protection is active)
Ignition fault
Boiler/system water pressure low
Call a qualified service technician
Manually resettable fault (
Fault in progress
7703471.01 (1-03/18)
)
4
Burner lit
DHW operating mode enabled
Heating mode enabled
Programming menu
Boiler information menu
Set unit of measurement (SI/US)