Installing The Adapter In A Server; Connecting The Network Cable - HP NC7771 User Manual

Installing the Adapter

Installing the Adapter in a Server

Refer to the HP ProLiant server documentation for additional information on how to safely
install a PCI card in the server.
Figure 2-1: Installing the adapter in a server
1. Remove the server cover and cover bracket from a PCI slot.
2. Firmly seat the adapter in the PCI slot and secure the adapter bracket.
3. Replace the server cover and plug in the power cord.

Connecting the Network Cable

Network connections for the NC7771 Server Adapter can employ existing Category 5 UTP
(or better) cable for Gigabit over copper transmissions. For new installations, Category 5e
(enhanced Category 5) or better cable is recommended.
To secure the cable, plug the cable connector into the RJ-45 port. Ensure that the tab on the
plug clicks into position, indicating that it is properly seated.
For more information, refer to "UTP Cable Specifications" in Appendix C.
2-2
HP CONFIDENTIAL Codename: Banshee II Part Number: 252458-00C Last Saved On: 7/28/03 10:29 AM
CAUTION: If the server is not PCI Hot Plug compliant, power it down and unplug the power
cord from the power outlet before removing the server cover. Failure to do so may damage
the adapter or server.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
HP NC7771 PCI-X Gigabit Server Adapter User Guide