Black & Decker DR330 Instruction Manual page 7

638911-00 02 DR drills
F
5
19
First Aid Measures for Gel Components (DR320KG Only)
If gel within the comfort grip becomes exposed and results in skin contact wash with soap
and water; for eye contact, flush with flowing water. If swallowed, seek medical attention.
Material Safety Data Sheet (MSDS) available from 1-800-544-6986
Safety Warnings and Instructions: Drills
WARNING: Shock hazard. When drilling or driving into walls, floors or wherever
live electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF
THE TOOL! Hold the tool only by the plastic handle(s) to prevent shock.
• Do not lock the tool ON when drilling by hand. Refer to Operating Instructions-Switch.
• Hold drill firmly with both hands to control the twisting action of the drill. If your
drill is equipped with a side handle, always use the side handle.
WARNING: Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly to control the twisting action and prevent loss of
control which could cause personal injury. If a stall does occur, release the trigger
immediately and determine the reason for the stall before re-starting.
• Always unplug the drill when attaching or removing accessories. When attaching
accessories in the drill chuck, it is important to securely tighten the chuck using all three
holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
Motor
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means your
drill will operate on standard 60 Hz household power. Do not operate AC tools on DC. A
rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz AC or DC
power. This information is printed on the nameplate. Lower voltage will cause loss of
power and can result in over-heating. All Black & Decker tools are factory-tested; if this
tool does not operate, check the power supply.
Assembly
WARNING: To reduce the risk of injury, before assembly, make sure that the tool is
switched off and unplugged.
Attaching the side handle - DR550 / DR650 (fig. A)
If your drill is equipped with a side handle, it must be installed properly to control the drill
• Turn the grip counterclockwise until you can slide the side handle (9) onto the front of the
tool as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop (8) into the mounting hole as shown (DR650).
• Set the drilling depth as described under "Setting the Drilling Depth (DR650)".
• Tighten the side handle by turning the grip clockwise.
3/20/08 10:20 AM Page 7
G
18
7
20
4