2-6 Setting the internal selector-
switches
Precautions for Correct Use
All the operations listed below must only be carried out when the receiver is disconnected to
the power supply.
Settings like operation mode, baud rate and distance can be changed by selector switches.
To access the selector switches unscrew the end cap of the receiver and transmitter unit:
There are two lines of dip switches in each transmitter and receiver. The settings must
be done for both lines. Change the setting of the dip-switch and close the cap again. The light
curtain can now be reconnected to the power supply.
The functions of dip-switches are explained in chapter 4-1 'DIP switch setting' on page 4-2.
F3EM2 MEASURING LIGHT CURTAINS OPERATION MANUAL
2-6 Setting the internal selector-switches
1
2
3
4
5
6
7
8
OFF
ON
1
2
3
4
5
6
7
8
OFF
ON
2-7
2