Ice Maker - Siemens GS Series Instructions For Use Manual

Ice maker

Fault
The ice maker doesn't work. Ice maker is not connected
The ice maker does not
make enough ice or the ice is
deformed.
Ice dispenser does not
function.
The "lock" and "on/off"
buttons flash.
Ice dispenser does not
function.
No ice cubes are dispensed.
Possible cause
to the power supply.
The ice maker is switched
off.
Ice maker is not receiving
any fresh water.
The freezer compartment
temperature is too warm.
Supply hose is kinked or
crushed. Fig. (
The appliance or ice maker
has only just been switched
on.
A lot of ice has been taken.
Low water pressure.
The freezer compartment
temperature is too warm.
Screen on the water supply
is dirty.
Water has escaped from the
pipe system.
The integrated AquaStop
system has interrupted the
water supply.
Ice maker is empty. All the
ice cubes have been
dispensed.
Remedial action
Call the customer service.
Switch on the ice maker (see "Ice maker").
Ensure that the water has been connected
properly.
Check freezer compartment temperature and,
if required, set slightly colder.
Ensure that the supply hose is installed
correctly.
Approx. 24 hours is needed until ice
production starts.
Approx. 24 hours is needed until the ice cube
container is filled again.
Connect the appliance to the stipulated water
pressure only (see chapter "Connecting
the appliance", section "Water connection").
Set temperature colder.
Clean the screen.
Switch off the water supply and inform
customer service (see chapter entitled Alarm
function).
Wait for more ice cubes to be produced.
en
21