Table of Contents
Advertisement
Occasionally ice cubes will freeze
together and block the dispenser:
1. Open the door and check inside
whether ice cubes are sticking to the
ice and water dispenser.
2. If the ice and water dispenser is not
blocked:
m
Caution
A full ice cube container is heavy!
Carefully pull out ice cube container
■
and remove ice cubes which are
frozen together.
When the ice cube container is full, ice
making switches off automatically.
When ice cubes are being made,
the buzzing water valve, the water
flowing into the ice cube tray and
the falling ice cubes can be heard.
All materials used in the drinks
dispenser are odourless and tasteless.
If the ice has an aftertaste, this may be
caused by:
Mineral and chlorine content
■
of the drinking water.
Material of the domestic water line
■
and connection line.
Freshness of the drinking water. If ice
■
has not been dispensed for a long
time, the ice may have a "stale" taste.
In this case remove approx. 30-40 ice
cubes and throw away.
Dispensing ice
Fig. &
Note
The ice maker must be switched on for
several hours before ice can be
dispensed.
1. Press ice dispenser On/Off button 1
for one second. When the ice
dispenser is switched on, the button
light is lit.
2. Select ice dispenser button (ice
cube 3 or crushed ice 4).
3. Press the glass against the dispenser
button until the required volume has
been dispensed.
Note
Depending on the amount of ice in the
ice cube container, it may take several
seconds until ice is dispensed.
Note
The amount of ice produced can be
increased by setting the lowest possible
temperature in the freezer compartment.
Disconnecting the ice maker
If ice cubes are not to be dispensed for
longer than 1 week (e.g. holiday),
temporarily disconnect the ice maker
to prevent the ice cubes from freezing
together.
en
15
Advertisement
Table of Contents
