Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
The IP-R Unit switch SW1 indicates to the system how the
adapter is powered.
To set Switch SW1 for the applicable power source, refer to
Table 9-5 Switch SW1 Setting for Power
Table 9-5 Switch SW1 Setting for Power Configuration
Switch
(SW1)
Setting
s
1
2
(Default)
3.7.3
Installing the IP-R Unit on the Multiline Terminal
The IP-R Unit can be installed on any DTH-8D/16D/32D-1/2 Multiline
Terminal as shown below.
1.
Unplug the telephone line from the terminal. Turn the terminal
upside down, press the areas indicated on the diagram and
raise the base plate until the retaining tabs click.
Power Method
AC Adapter
NEC POE Equipment
CICSO Equipment
(CDP)
Document Revision 3
Configuration.
Equipment Used
NEC AC-2R/AC-3R AC
Adapter (27V, 750 mA)
H
NEC Power Patch Panel
SN1604 PRWMS (Stock
No. 59022)
H
NEC BF200/24 POE
Switching Hub
H
Cisco Catalyst PRW
Series
H
Cisco Powered Patch
Panel
9 - 31