Com Transmit Power Configuration Page; Figure 6-21. Configure Taws Audio Page; Figure 6-22. Com Transmit Power Configuration Page - Garmin GTN 635 Installation Manual

TAWS AUDIO
Access the Configure TAWS Audio page, as shown in
Figure 6-21, by touching the ‗Configure TAWS Audio'
key on the TAWS Configuration page. Select which
message is heard for cautions and warnings.
Description
NCR Caution
EDR Caution
PDA Caution
IOI Caution
ROC Caution
ITI Caution
RTC Caution
IOI Warning
ROC Warning
ITI Warning
RTC Warning
EDR Warning
VCO Caution
AIRPORT CRITERIA
Configure TAWS airport criteria from the TAWS Configuration page, as shown in Figure 6-20. Touch
‗Runway Surf.' key to select the applicable runway surface type. The selections are Any, Hard Only,
Hard/Soft, and Water.
Enter the minimum runway length by touching the ‗Min. Length' key using the keypad. The range is 0 to
25,000 ft.
6.7.2

COM Transmit Power Configuration Page

Access the COM Transmit Power Configuration page, as
shown in Figure 6-22, by touching the ‗COM' key on the
GTN Options page. This page allows you to select the
transmit power mode. Selections are Normal and 16W.
A 16W COM Enablement Card (P/N 010-00878-04)
is needed for 16W COM.
GTN 625/635/650 TSO Installation Manual
190-01004-02
Selections
"Don‟t Sink"
"Too Low Terrain"
"Sink Rate"
"Too Low Terrain"
"Obstacle Ahead" x2
"Caution Obstacle" x2
"Obstacle Ahead" x2
"Caution Obstacle" x2
"Terrain Ahead" x2
"Caution Terrain" x2
"Terrain Ahead" x2
"Caution Terrain" x2
"Obstacle Ahead Pull Up" x2
"Obstacle" x2 "Pull Up" x2
"Obstacle Ahead Pull Up" x2
"Obstacle" x2 "Pull Up" x2
"Terrain Ahead Pull Up" x2
"Terrain" x2 "Pull Up" x2
"Terrain Ahead Pull Up" x2
"Terrain" x2 "Pull Up" x2
"Pull Up"
"Five Hundred"
NOTE

Figure 6-21. Configure TAWS Audio Page

Figure 6-22. COM Transmit Power
Configuration Page
Page 6-17
Rev. C