Table of Contents
Advertisement
Quick FIM-7920E configuration
MGMT 1 to MGMT 4 of each FIM-7920E are configured as a static aggregate interface called mgmt and all have the
same IP address. If you have two FIM modules installed in your chassis, then MGMT 1 to MGMT 4 of both modules are
all in the same static aggregate interface.
At any time during the configuration process, if you run into problems, you can reset the FIM-7920E to the factory
defaults and start over. From the CLI enter
Connect to the GUI by connecting MGMT1 of the module in slot 1 to your network and browsing to
https://192.168.1.99. Log into the GUI using the admin account with no password. Go to Network > Interface and
configure the FIM-7920E interfaces to connect to your network.
FIM-7920E Processing Module Guide
execute factoryreset .
26
Fortinet Technologies Inc.
Advertisement
Table of Contents
