Fortinet FIM-7920E Manual page 18

Hardware installation
6. Tighten both secure screws to close the gap between the module and the chassis.
Begin by engaging the secure screws into the chassis tapped hole by hand and roughly tighten them. Then use a Phillips
screwdriver to fully tighten the two secure screws. Do not use a power screwdriver, because the high torque and speed
can damage the chassis or screw thread. After tightening both secure screws, the module is fully seated in the chassis
slot and the module connectors are fully in contact with the chassis backplane.
FIM-7920E Processing Module Guide
Tighten by hand
Fully tighten with a
screwdriver
After tightening both secure
screws, the module is fully
engaged with the chassis.
Fortinet Technologies Inc.
18