Table of Contents
Advertisement
Hardware installation
To complete this procedure, you need the following equipment and tools:
a FortiGate-7000 chassis with a FIM-7920E module installed
l
an electrostatic discharge (ESD) preventive wrist strap with connection cord
l
a Phillips screwdriver
l
1. Shut down the module operating system properly.
To avoid potential hardware problems, always shut down the module operating system properly before removing the
module from a chassis slot or before powering down the chassis. To shutdown the module, connect to the module GUI
Shutdown from the administrator menu. Or, from the module CLI, enter the execute shutdown
and select
command.
2. Disconnect all cables from the module, including all network cables and USB cables
or keys.
FIM-7920E Processing Module Guide
Do not carry the FIM-7920E by holding the module levers or secure screws. When inserting or
removing the FIM-7920E from a chassis slot, handle the module by the front panel. The
levers are not designed for carrying the module. If the levers become bent or damaged, the
FIM-7920E may not align correctly in the chassis slot.
FIM-7920Es must be protected from static discharge and physical shock. Only handle or work
with FIM-7920Es at a static-free workstation. Always wear a grounded electrostatic discharge
(ESD) preventive wrist strap when handling FIM-7920Es. (An ESD wrist strap is not visible in
the photographs below because they were taken in an ESD safe lab environment.)
20
Fortinet Technologies Inc.
Advertisement
Table of Contents
