Page 1
(1) this device may not cause harmful interference and (2) this device must accept any interference that may cause undesired operation. REMOTE KEYLESS ENTRY SYSTEM FORESTER P/N: H7110FS300 ” Drive Extension 99.11 UT27T-11 Printed in Japan...
A. Pre-Installation Notes 1. Vehicle Preparation a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle during installation. b. Note and record station presets on radio for step #2 in section E. Finish the Installation. c.
Page 3
3. Remove two M6 nuts, indicated by arrow in Figure 3, securing both the door lock timer module. Retain nuts for installation of keyless entry module. Disconnect the door lock timer harness from the module and discard the module. Disconnect 6-pin to 16-pin extension harness from the 16-pin (white housing) connector.
Page 4
C. System Test 1. Reconnect the negative battery terminal. 2. Close all vehicle doors (with dome light switch set to “Doors”). 3. Depress the LOCK/ARM button on the remote and the following should be observed: All vehicle doors will lock The vehicle courtesy (dome) light will turn off The horn will chirp once.
Page 5
E. Finish the Installation 1. Replace the lower dash panel below the steering column previously removed in section B. 2. Reset presets on radio as noted in step 1. b. in section A. Pre-Installation Notes. Installation is now complete.