6.3.1 Verify Device Communications; Figure 15: Web Configurator Showing Active Profile Additions - Siemens ProtoAir FPA-W44 Startup Manual

•
To add an active profile to support a device, click the Add button under the Active Profiles heading.
This will present a drop-down menu underneath the Current profile column that lists all the available
profiles.
•
Once the Profile for the device has been selected from the drop-down list, enter the value of the
device's Node-ID which was assigned in Section 3.3.2.
•
Then press the "Submit" button to add the Profile to the list of devices to be configured.
•
Repeat this process until all the devices have been added.
•
Completed additions are listed under "Active profiles" as shown in
NOTE: If multiple devices are connected to the ProtoAir, set the BACnet Virtual Server Nodes field
to "Yes"; otherwise leave the field on the default "No" setting.

6.3.1 Verify Device Communications

•
Check that the port R1 TX1 and RX1 LEDs are rapidly flashing. See
additional information and images.
•
Confirm the software shows communication without errors. Go to

Figure 15: Web Configurator Showing Active Profile Additions

Page 21 of 66
Siemens ProtoAir Start-up Guide
Figure 15.
Appendix A.4
Appendix A.2
for instructions.
for