Fagor FA16542 Operating And Installation Instructions page 33

Reversing the direction the door opens
When the door is ready, prepare the freezer
compartment:
- Carefully remove the top pivot M from the eight-
hand side of the freezer compartment (Drawing R8).
- Insert it in the left-hand housing (Drawing R8).
- Proceed in the same way with the compartment's
stop N; unscrew it from its original position on the
left.
- Fit it into its housing on the right-hand side and
screw it in place.
You can now re-attach the freezer compartment's
door:
- Carefully insert the door into the pivot (Drawing R9)
- Fit the bottom hinge in its housing and screw in
screw G (Drawing R9) to fix it.
- Close the compartment door.
- Close the appliance's door.
Adjusting the hinge
Sometimes the top door and the strip are not perfect-
ly aligned (Drawing R10). In this case, unscrew the
fixing screw slightly from the cover (A) over the top
hinge. Then screw it in again and check that the seal
is perfectly hermetic.
Reversibility of the handle
Unscrew the handle from the left-hand side and
refit it on the right-hand side (Drawing R11). Use
the handle to determine the position of the new
holes (2.5 mm diameter) for fixing the handle.
If the doors already have holes on both sides:
Remove the plugs covering the handle's screws
and those on the opposite side covering the
holes. Unscrew the handle and place it on the
other side (see Drawing R11). Screw the handle
on and insert the plugs covering the screws and
the holes.
N
33
Drawing R8
M
Drawing R9
Drawing R10
Drawing R11
EN
G