Table of Contents
Advertisement
Operation
7.2 Monitoring
7.2.11
Example of a monitoring configuration
The following simple example is intended to illustrate the steps for a monitoring configuration
as explained above.
Assumptions
● A water tank holds 100 liters. If the 100 liters is exceeded, and alarm message will be
sent to the maintenance staff in the form of an SMS message.
● The maintenance staff consists of two employees, employee "User-1" and employee
"User-2" whose phone numbers are known.
● A fill level sensor is connected to input no. 1 of the LOGO! BM:
If the measurement indicates that the amount of liquid has been exceeded (> 100 liters in
the tank), the fill level sensor sets digital input no. 1 to "1".
Procedure
Requirement: The CMR and BM must be connected via an Ethernet cable.
1. In the "LOGO! BM" tab, enter the address of the BM in the "IP address of the LOGO! BM"
input box.
2. Select the "Active" check box so that the CMR establishes a connection to the BM.
Figure 7-14
114
Users / groups - "LOGO! BM" tab: Establishing a connection to the BM
LOGO! CMR2020 / LOGO! CMR2040
Operating Instructions, 09/2014, C79000-G8976-C356-01
Hide quick links:
Advertisement
Table of Contents
