Rooms are too cold
Cause
The heating system is switched off.
■ Control unit incorrectly adjusted.
■ The room temperature controller (if in-
stalled) is set incorrectly.
Separate operating instructions
Message code 06 flashes.
on
Symbol
is shown and message code
F02, F03, F04, F05, F07 or F08 is flash-
ing.
Remedy
■ Turn on the ON/OFF switch (see dia-
grams from page 10).
■ Switch the mains isolator ON (if instal-
led).
■ Check the MCB/fuse in the power dis-
tribution board (main domestic MCB/
fuse).
Central heating must be enabled.
Check the settings and correct if re-
quired:
■ Operating program (see page 20)
■ Room temperature (see page 18)
■ Time program, central heating (see
page 20)
■ Heating curve (see page 24)
The pressure in the heating system is
too low. Top up with water or notify your
local heating contractor.
Simultaneously press keys MODE and
OK, until the
symbol flashes (reset).
Contact your local heating contractor if
the fault reappears on the display.
What to do if...
35