Suzuki Jimny Manual page 51

Approval mark to meet child
restraint system regulation for UN
R44 / R129 regulation
The following mark is shown on the child
restraint system to meet the regulation of
UN R44 / R129 for the child restraint sys-
tem.
(1)
(2)
(3)
(5)
(6)
(7)
78RB01010
(1) Regulation number
(2) Suitability for child restraint system
category
(3) Weight range of the applicable child
who is applicable for this approval
mark as shown in the mark
(4) Height range and weight range of the
applicable child who is applicable for
this approval mark in the mark
(5) Specification of appliance
(6) Country code which approved child
restraint system
(7) Approval number of child restraint seat
This approval mark is a representative
example.
NOTE:
• UN R44 / R129 means the international
regulation for the child restraint system.
• "ECE" is shown on the mark in the illus-
tration for the child restraint system. This
"ECE" mark is the same as "UN".
(4)
FOR SAFE DRIVING
Installation with lap-shoulder seat
belts
CAUTION
If your vehicle is equipped with the
head restraint, adjust the height of
the head restraint or remove it for fit-
ting the child restraint, as necessary.
However, if a booster cushion not
equipped with the head restraint is
fitted, the head restraint should not
be removed. If the head restraint is
removed for fitting the child restraint,
you need to install it again after
removing the child restraint.
If the child restraint is fitted improp-
erly, a child sitting in it could be
injured in a collision.
NOTE:
Stow the removed head restraint in the
luggage compartment so it will not cause
inconvenience to the occupants.
78RB1-01E
1-32