Siemens SIMATIC PCS 7 Programming And Operating Manual page 62

Operating and monitoring SFCs
6.19 Information and operator input in the detail view
An operator prompt (not with "T") is represented by the button to the left of the transition symbol:
After clicking this button - or the following:
and continuing the sequence, the buttons disappear again.
Buttons and check boxes
● "Synchronize" check box
If this check box is selected, the overview is synchronized to the detail view.
● "Sequencer Properties" button
Use this button to open the dialog box with the object properties of the current sequencer.
For further information, refer to the section: "Properties" Dialog Box for the Sequencer
(Page 70)
● "Start Condition" button
Use this button to open the dialog box for the start conditions of the current sequencer.
For further information, refer to the section: "Properties" Dialog Box for the Start Condition
(Page 71)
● Button to open a resizable window
Click this button to open the detail view in a resizable window.
At the bottom edge of the view:
You can change between the sequencers of an SFC using the tabs at the lower edge of the
detail window.
In the overview:
● Selection of a view from the drop-down list
● "Synchronize" check box
If this check box is selected, the overview is synchronized to the detail view.
● Button to open a resizable window
Click this button to open the overview in a resizable window.
In the control and display area:
Setting the Operating Mode (Page 64)
Setting the Operating State (Page 65)
Setting the Step Control Mode (Page 66)
62
Programming and Operating Manual, 05/2017, A5E41356392-AA
SFC Visualization (V9.0)