c§3 Fan Speed Selection
When pushing one of these buttons @ , Q , f § or button
P , the fan speed will correspond to the particular position
of lever (4).
The volume of fresh air supplied to the vehicle interior can
be increased by pushing lever (4) to the right.
The fan speed may be changed by moving lever (4) to
position " II" , " III" or " m ax" . The fresh air intake may be
temporarily closed (press push button ^
through dusty areas or annoying odors enter the car inte
rior.
Function §
= Continous max. air volume.
jH E M Air Recirculation Switch
Pressing the switch (symbol-side) down, causes air to be
recirculated with only a small amount of fresh air. The
indicator lamp should be on (do not push §§ button). This
setting can also be used if annoying odors are entering
the car's interior. At high outside tem peratures the air con
ditioning system is autom atically switched on, providing
increased cooling of the recirculated air.
20
Fast Cooling
•
Turn temperature selector wheel (1) and lock in extre
me end position " MIN" .
•
Push button @
•
Push @ button.
•
Push lever (4) to far right " m ax" position.
•
For maximum air flow push up levers (7) and
•
Close windows and sliding roof completely.
) if driving
Open the windows and/or sliding roof long enough to let
hot air inside the car escape. This helps reduce the time
the air conditioner must run before the car cools. Then,
close windows and/or sliding roof and allow air conditioner
to operate normally.
or § | ) in climate control switch (3).
(9).