Jeep Patriot 2011 Operating Information Manual page 96

Front Fog Lights
The front fog light switch is on the
multifunction lever. To activate the front
fog lights, turn on the position lights or
the high/low beam headlights and pull
out the end of the multifunction lever.
Front Fog Light Control
Rear Fog Lights
The rear fog lights may be operated
as desired when visibility is poor due
to fog. To activate the rear fog lights,
turn on the front position lights or the
92
headlights, pull out the end of the multifunction
lever and rotate the lever to the last detent.
Turn Signals
Move the multifunction lever up or down and
the arrows on each side of the instrument
cluster flash to show proper operation of the
front and rear turn signal lights.
Turn Signal Control
If either light remains on and does not flash, or
there is a very fast flash rate, check for a
defective outside light bulb. If an indicator fails
to light when the lever is moved, it would
suggest that the indicator bulb is defective.
Lane Change Assist
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.
High/Low Beam Switch
Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
lever back toward you, to switch the headlights
back to low beam.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will turn on the high beam
headlights until the lever is released.
NOTE:
If the multifunction lever is held in the flash-
to-pass position for more than 15 seconds,
the high beams will shut off. If this occurs,
wait 30 seconds for the next flash-to-pass
operation.
Instrument Panel Dimmer
Rotate the center portion of the lever to the
extreme bottom position to fully dim the instru-