Installation Instructions; Unpack The Ice Maker; Location Requirements - KitchenAid KUID308HPS Installation Instructions Manual

WARNING
: To reduce the risk of fire, electric shock, or injury when using your ice maker, follow these basic
precautions :
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Connect to potable water supply only.
Children should be supervised to ensure that
they do not play with the appliance.
Disconnect power before servicing.

Unpack the Ice Maker

WARNING
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
Removing Packaging Materials
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue from the exterior of the
■
ice maker, rub the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a small amount
of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. Do not
use chlorine bleach on the stainless steel surfaces of the ice
maker. These products can damage the surface of your ice
maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside
of your ice maker before using it. See the cleaning instructions in
the "Ice Maker Care" section.
2
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Disconnect power before manually cleaning the inside components.
Replace all parts and panels before operating.
Use two or more people to move and install ice maker.

Location Requirements

To ensure proper ventilation for your ice maker, the front
■
side must be completely unobstructed. The ice maker may
be closed-in on the top and three sides, but the installation
should allow the ice maker to be pulled forward for servicing if
necessary.
Installation of the ice maker requires a cold water supply inlet
■
of 1/4" (6.35 mm) OD soft copper tubing with a shutoff valve
or a Whirlpool supply line Part Number 8212547RB, and a
Whirlpool approved drain pump, Part Number 1901A, only to
carry the water to an existing drain.
Choose a well-ventilated area with temperatures above 55°F
■
(13°C) and below 110°F (43°C). Best results are obtained
between 70°F and 90°F (21ºC and 32°C).
The ice maker must be installed in an area sheltered from the
■
elements, such as wind, rain, water spray, or drip.
When installing the ice maker under a counter, follow the
■
recommended opening dimensions shown. Place electrical
and plumbing fixtures in the recommended location as shown.
NOTES:
Check that the power supply cord is not damaged or
■
pinched or kinked between the ice maker and the cabinet.
Check that the water supply line is not damaged or
■
pinched or kinked between the ice maker and the cabinet.
Check that the drain line (on some models) is not
■
damaged or pinched or kinked between the ice maker and
the cabinet.