How To Read This Chapter - NEC UNIVERGE SV8300 Command Manual

HOW TO READ THIS CHAPTER

Information about each command is presented in the following order:
(1) FUNCTION: The function of the command.
PRECAUTION: Precautions related to assigning data.
(2)
ASSIGNMENT PROCEDURE: The procedure for assigning data in CAT mode.
(3)
DATA TABLE: Detailed descriptions of the data.
(4)
In the description of each command, the following symbols are used.
: Default which is automatically loaded into the memory, after system reset by setting
position "A" on SENSE switch of the CPU, followed by a reset.
: Commands which require a reset of the CPU blade after data setting.
RESET
: Commands which can be used only under Off-Line mode of the CPU blade.
OFF LINE
To set Off-Line mode,
(1)
(2)
: Commands which require a reset of the blade by CME0 Y=3 after data setting.
BLADE RESET
: Commands which require a reset of the IPT (P2P CCIS) by CME0 Y=5>01 after data
IPT (P2P CCIS) RESET
setting.
You should confirm the meaning of default, and change or delete the data, if required.
Set SENSE switch on the CPU blade to "E" or "F".
Press RESET switch on the CPU blade.
Chapter 3 COMMAND DESCRIPTION
3-2
HOW TO READ THIS CHAPTER HOW TO READ THIS CHAPTER
NWA-033623-001 Rev.8.1
91ch3001.fm