Roland Sign Maker CAMM-1 PNC-1050 User Manual page 33

Inst. Format
SC Xmin, Xmax, Ymin, Ymax;
SC
SC;
SI w, h;
SI
SI;
SL tanØ;
SL
SL;
SM s;
SM
SM;
SR w, h;
SR
SR;
SS SS;
TL lp(,lm);
TL
TL;
UC (c,)∆x, ∆y,(c,)
,....,∆xn, ∆yn;
UC
UC;
VS v;
VS
VS;
WDc1c2...cn[label terminator]
WD
WD[Label terminator]
WG WG r,Øl,Øc(.Ød);
XT XT;
XY YT;
mode1, mode2 common instructions
Inst. Format
!NR !NR ;
!PG !PG n ;
!ST !ST n ;
26 26
* 1 : - ( 2 ) — + ( 2 -1 )
) °— + ( 2
26 26
* 2 : - ( 2
26
* 3 : 0 — + ( 2 -1 )
Meaning of Parameter [Parameter Range (Default)]
Xmin, Ymin : User XY coordinates of P1 [*1]
Xmax, Ymax : User XY coordinates of P2 [*1]
w : Character width (cm) [-128 — +127.99999 (3.8)]
h : Character height (cm) [-128 — +127.99999 (5)]
tanØ : Character slant [*1 (0)]
s : Character or symbol [CHR$(33) — CHR$(58), CHR$(60)—
CHR$(126)
(Default : Clears symbol mode)]
w : Character width (%) [*1 (3.8 cm)]
h : Character height (%) [*1 (5 cm)]
None
lp : Tick length in positive direction [*2 (0.5%)]
lm : Tick length in negative direction [*2 (0.5%)]
c : Tool control value [-67108863 — -99, +99 — +67108863]
∆xn : Units of movement in X-axis direction [-99<∆xn<+99]
∆yn : Units of movement in Y-axis direction [-99<∆yn<+99]
v : Tool speed (cm/sec.) [1 — 20 (value set by cotrol panel)]
cn:character[CHR$(32)-CHR$(160)-CHR$(223)
r : Radius Øl : Startangle[l*]
Øc : Center angle[l*] Ød : chord tolerance[*l(5°)]
None
None
Meaning of Parameter [Parameter Range (Default)]
None
n : [-1600 — +1600 mm]
n : [0, 1]
-1 )°
31
Explanation
Scaling
Absolute Character Size
Character Slant
Symbol Mode
Relative Character Size
Select Standard Set
Thicke Length
User Definesd Character
Velocity Select
Write to Display
Shad Wedge
X-Tick
Y-Tick
Explanation
Not Ready
Page Feed
Select Tool