Table of Contents
Advertisement
7. If the sheet was not cut correctly in steps 1 through 6 of the cutting test, change the cutting conditions.
• Changing the Pen Force
Use the pen force control on the top of the unit to adjust pen force knob to the appropriate setting. When
the pen force control is rotated all the way counterclockwise, the tool pressure is 30 g (minimum setting).
Pen force increases as the control is rotated clockwise, to a maximum of 200 g. During the cutting test,
Pen force is indicated in the upper right area of the display screen. Use this display when adjusting pen
force.
• Changing the Speed
1. Speed can be changed either in the setup mode or in the cutting mode. This explanation describes how
to change speed when in the cutting mode. When the cutting test screen is displayed, press the
three times to display the following message.
2. Use the
and
the
key. When the following message appears, use the
ENTER
press the
key.
ENTER
• Changing the Offset
1. While the cutting test screen is displayed, press the
2. Use the
and
When the following message appears, use the
the selection by pressing
8. One offset unit is equal to 0.025 mm. This means that the offset value in the procedure described above
is 0.25 mm. Whenever the cutting conditions have been modified, it is recommended that you once again
perform a cut test to confirm correct positioning and orientation.
The Chart below describes symptoms that occur when cutting conditions are not optimal. Use this chart for
comparison with the results of the cutting test .
keys to select first [TOOL,] then [CUTTER,] and enable these selections by pressing
keys to select [OFFSET,] and press the
key.
ENTER
S e t t i n g
Condition
Too small
Some parts of the sheet remain uncut
Force
The base paper is cut, and the cutter requires
Too large
frequency replacement
Too fast
Some parts of the sheet remain uncut
Speed
Too slow
Operating efficiency is reduced.
Too small
Corners are rounded
Offset
Too large
Corners flare outward, with "horns"
0
TEST CUT
30g
1:
PEN FORCE
SELECT HIT"ENTER"
TOOL FONT PEN-CHANGE
and
SETSPEED
CUTTER
20
key seven times.
MENU
SELECT COMPENSATION
OFFSET
SMOOTHING
key to enable the selection.
ENTER
and
keys to change the offset value, and enable
SET OFFSET VALUE
10
Cutting result
14
2:
3:
MENU
keys to change the speed, then
cm/s
key
Hide quick links:
Advertisement
Table of Contents
