Pentair INTELLICHLOR IC15 Installation And User Manual page 6

iv
CAUTION - Use of chemicals other than those recommended may be hazardous. Even proper use of the
CAUTION - To reduce the risk of electric shock, install IntelliChlor
CAUTION - Install the SCG a minimum of 90 cm (3 ft) away from the heater outlet.
CAUTION - A solid copper, bonding conductor not smaller than No. 8 AWG (8.4 mm) should be connected from
the accessible wire connector on the unit to all metal parts of the swimming pool, spa, or hot tub structure and to all
electrical equipment, metal conduit, and metal piping within 1.5 m (5 ft) of the inside walls of a swimming pool, spa,
or hot tub, when the unit is installed within 1.5 m (5 ft) of the inside walls of the swimming pool, spa, or hot tub.
WARNING: When mixing acid with water;
ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
Canada - Industry Canada (IC) - This device complies with RSS210 of Industry Canada. (1999)
.
CAUTION - The IC15 Power Supply must be interconnected with pool pump motor power source. This ensures
the SCG and pool pump will switch on and off together. When the IC15 (SCG) is installed in Europe, IC15 (SCG)
Power Center supply fuses should ONLY be obtained from the manufacturer.
CAUTION - The IC15 Power Supply is only intended for use with the IC15 cell, DO NOT PLUG ANY
OTHER INTELLICHLOR CELL INTO THIS POWER SUPPLY, SEVERE DAMAGE WILL RESULT.
IntelliChlor Salt Chlorine Generator Installation and User's Guide
IMPORTANT WARNINGS AND SAFETY INSTRUCTIONS
recommended chemicals can be hazardous. Follow the Chemical Manufacturer's Instructions.
a minimum of 1.5 m (5 ft) away from the inside wall of the pool.
®
Salt Chlorine Generator (SCG)