Model: ....Type: ... (Year) ..S/N° ....M O W I N G A H E A D w w w.
Stigas benzindunk anven- vi bruk av Stigas bensin- används. Den finns hos nestesäiliötä. Niitä on des. Den kan fås hos kanne. Den er å få hos auktoriserade Stiga åter- saatavana valtuutetuilta autoriserede Stiga-for- autoriserte Stiga-forhand- försäljare och har artikel- Stiga-jälleenmyyjiltä osa-...
SAFETY REGULATIONS A) TRAINING 1) Read the instructions carefully. Get familiar with the controls and proper use of the equip- ment. Learn how to stop the engine quickly. 2) Only use the lawnmower for the purpose for which it was designed, i.e. for cutting grass. Any other use can be hazardous, causing damage to the machine.
Regular maintenance is essential for safety and performance. 2) Never store the equipment with fuel in the tank inside a building where vapour may reach a flame or a spark or a source of extreme heat. 3) Allow the engine to cool before storing in an enclosed space.
IMPORTANT For the instructions relative to the engine and the battery, please read the relevant instruction handbooks. Equipment which is marked with an asterisk (*) comes as standard in certain models or countries. Certain models do not have throttle control. The engine’s speed is set for optimal function and min- imal exhaust emissions.
attempts at starting in order to prevent dis- charging the battery. 6. For the best mowing results, the engine should always be driven at full throttle. STOPPING THE ENGINE The engine may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling flanges.
LUBRICATING DRIVE SHAFT (*) Once per season, the wedge on the drive shaft should be greased. Remove the wheel (wheel cap, screw and washer). Then remove the circlip and washer so that the gear wheel can be removed from the shaft. Lubricate the wedge with universal grease.
ENGLISH Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade screw should also be replaced. SHARPENING THE BLADES Sharpening of the blades must be done by wet method grinding, using a whetstone or a grind- stone.