Replacing The Hydraulic Filters - Toro Reelmaster 7000-D Operator's Manual

3. Disconnect the case return line from the bottom
of the reservoir and let the hydraulic fluid flow
into a large drain pan.
4. Connect the line when the hydraulic fluid stops
draining.
5. Fill the reservoir with approximately 28.4 L
(7.5 US gallons) of hydraulic fluid; refer to
Checking the Level of the Hydraulic Fluid (page
67).
Important:
Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
6. Install the reservoir cap.
7. Start the engine and use all of the hydraulic
controls to distribute hydraulic fluid throughout
the system.
8. Check for leaks and shut off the engine.
9. Check the fluid level and add enough to raise
the level to the Full mark on the dipstick.
Note:
Do not overfill the hydraulic system.
Replacing the Hydraulic
Filters
Service Interval: After the first 200 hours
Every 800 hours
Change the 2 hydraulic filters initially after the first 200
operating hours. Thereafter, change the filters after
every 800 operating hours, in normal conditions.
Use Toro replacement filters Part No. 94-2621 for the
rear (cutting unit) of the machine and 75-1310 for the
front (charge) of the machine.
Important:
Use of any other filter may void the
warranty on some components.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Clean the area around the filter mounting area.
3. Place a drain pan under the filter and remove
the filter (Figure 107
4. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
and Figure 108).
1. Hydraulic filter
1. Hydraulic filter
5. Ensure that the filter mounting area is clean.
6. Screw the filter on until the gasket contacts
the mounting plate; then tighten the filter an
additional 1/2 turn.
7. Start the engine and let it run for about 2 minutes
to purge air from the system.
8. Shut off the engine and check for leaks.
69
Figure 107
Figure 108
g009723
g200374