Installing The Fan Tray From The Front - Cisco Catalyst 9404R Switch Hardware Installation Manual

Removing and Replacing FRUs

Installing the Fan Tray from the Front

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Before you begin
You have completed the procedure to get the replacement fan tray ready for installation. There is a time
constraint when you remove and replace the fan tray in a system that is powered on. The system can safely
run without a fan tray only for 2 minutes.
You may need a Phillips-head screwdriver.
Procedure
Step 1 Hold the fan tray assembly with the fans facing to the right.
Step 2
Place the fan tray into the fan tray bay so it rests on the chassis, and then lift the fan tray up slightly, aligning
the top and bottom guides.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
Installing the Fan Tray from the Front
83