Installing The Display Assembly - Dell Latitude 7389 2-in-1 Owner's Manual

CAUTION:
damage.
b Lift the display assembly away from the computer [2].

Installing the display assembly

1 Place the base of the computer on a flat surface.
2 Install the display assembly by aligning it with the display hinge screw holders.
3 Replace the M2.5 x 4.0 screws to secure the display assembly.
4 Close the display assembly and flip the computer.
5 Connect the cables:
a G-sensor and eDP cable
b Place the eDP bracket on the eDP cable and replace the M 2 x 1.7L screw on the bracket.
c IR camera and touch screen cables
6 Route the antenna cables through the routing clips
7 Affix the tapes to secure the antenna cables to the system board.
8 Install the:
a WWAN card
b WLAN card
c battery
d base cover
e SIM card
f MicroSD card
NOTE: To install both cards if equipped.
9 Follow the procedure in
26 Extracción e instalación de componentes
Hold the LCD assembly in place as the screws are removed, to prevent it from falling over and possible
After working inside your computer.