Fiat 500 C Owner's Handbook Manual page 46

Hide thumbs Also See for 500 C:
Table of Contents

Advertisement

The signal is similar for obstacles in the
rear left or right area. The arc that
corresponds to the position of the
obstacle will flash.
The colour on the display depends on
the distance from and position of the
obstacle.
The car is close to the obstacle when
the display shows a single constant arc
and emits a continuous sound. If there
are several obstacles, the closest
approaching one is indicated.
Fault indications
Any parking sensor faults will be
indicated when reverse is engaged by
è
the warning light
or of the icon
on the colour display on the instrument
panel and by the relevant message in
the display (for versions/markets,
where provided).
Operation with a trailer
Sensor operation is automatically
deactivated when the trailer's electrical
cable plug is inserted.
44
START&STOP
SYSTEM
The Start&Stop device automatically
stops the engine each time the vehicle
is stationary and starts it again when
the driver wants to move off.
In this way, the efficiency of the car is
increased, by reducing consumption,
emissions of harmful gases and noise
pollution.
The system is active every time the
engine is started.
t
OPERATING MODES
18)
Engine stopping mode
❒ With manual gearbox: with the
vehicle stationary, the engine stops
with the gearbox in neutral and the
clutch pedal released.
❒ With Dualogic gearbox: the
engine stops if the vehicle is at a
standstill and the brake pedal is
pressed. This condition can be
maintained even if the brake pedal
is not depressed, if the gear lever is
in position N.
NOTE: the engine can only be stopped
automatically after a speed of about 10
km/h is reached, to prevent the engine
from being repeatedly stopped when
driving at walking pace.
❒ The warning light
instrument panel indicates that the
engine has stopped, on some
versions this indication is given by
the display.
Engine restarting mode
❒ With manual gearbox: the
information is given by pressing the
clutch pedal.
❒ With Dualogic gearbox: if the gear
lever is in position N, place it in any
other gear, otherwise release the
brake pedal or move the gear lever
to +, – or R.
U
on the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

500

Table of Contents