Table of Contents
Advertisement
Tools Required for Assembly
1 - Level
1 - 1 1/8" Open end wrench or adjustable wrench
1 - Tape measure
2 - 3/4" Open end wrenches or ratchet & socket
1 - 9/16" Open end wrench
1 - 9/16" Socket & ratchet or additional wrench
1 - 8' Step ladder or Telescopic folding ladder - Preferred
1 - Can of spray adhesive - Optional but highly recommended
*Spray adhesive can be found at many hardware stores. (Loctite Brand or 3M)
Note: Do not use an impact gun on stainless steel hardware.
Stainless steel hardware will commonly lock up or seize on itself before being fully tightened. It is important to apply a small
amount of grease or an anti-seize lubricant designed for stainless steel hardware before threading on the nut.
Experienced Installer Tip: A great deal of success has been had using the spray adhesive as an anti-seize lubricant during the
assembly process. Simply apply the spray adhesive to the bolt threads before threading on the nut and tighten with hand tools as
you normally would.
STEP 1 - PREPARE ANCHOR
•
Remove the (#3) nuts, (#4) washers and the (#1) template from the (#2) L-Bolts leaving the four (#3) nuts that are located below
the (#1) template as they will be forever embedded in concrete.
•
Thread one (#3) nut all the way down on to each (#2) L-Bolt resting against the nuts embedded in the concrete.
•
Lay a level across each pair of (#3) nuts leveling them from front-to-back and left-to-right.
•
Place a (#4) washer on top of each (#3) nut after leveling.
DAY 5
ASSEMBLY AND INSTALLATION
PAGE 6
888.496.5137
b
h
g
all
og
oals.com
Advertisement
Table of Contents
