STEP 10 -RIM ATTACHMENT
Experienced Installer Tip: Apply a small amount of spray adhesive to the backside of the (#12) rubber octagon and adhere it to the
backboard centered between the rim standoff tubes.
•
Using the hardware attached to the rim cover plate, attach the rim to the backboard as shown in Image 11. Snug hardware, do not
fully tighten at this time.
•
Place a level across the rim side-to-side and adjust the rim until it is level.
•
Finish tightening the four (#21) nuts.
Image 11
NOTE: RIM IS NOT SHOWN FOR CLARITY
31
13
13
31
13
13
31
DETAIL #5-A (FRONT)
ATTACHING RIM TO
BACKBOARD
PAGE 15
b
all
12
RUBBER OCTAGON IS
TO BE PLACED
IN BETWEEN RIM
AND GLASS, AS SHOWN.
13
21
13
21
13
21
13
21
DETAIL #5-B
RIM TO BACKBOARD
(REAR)
888.496.5137
h
g
og
oals.com